Arbor Workflows: Form: PDF responses

How to Enable PDF Generation 

To ensure appropriate steps are automatically saved as PDFs to be able to attach them or surface on the workflow run, you must update the Workflow configuration. This will take affect for all future runs of the workflow.

  1. Go to Workflows

  2. Select the specific workflow by clicking on the title. This will open the workflow builder.

  3. Open the Form Step. This will start with the settings.
  4. Ensure the PDF checkbox is ticked (this triggers a PDF creation for every form submission).

  5. If you are making this change after your workflow is live or if it ready to make live, go to Review & Test.
  6.  
  7. Critical Step: Add the PDF for that specific step by clicking 'Select Documents' under 'Which documents should be available on the run?  This means it attaches to the workflow run information and can be surfaced more easily.

Once you select Select Document this will open the Dynamic Data. From here you can add the PDF produced as part of the workflow, or document uploaded into the workflow.

 

Depending on how the workflow has been set up it may be possible to fetch the PDF of a form if it was not added in this way. This requires going through each step and update to the workflow to see if the PDF has been added anywhere else in order to surface from outside of the workflow - for example, in a message or update that was sent as part of the workflow. 

This may not be possible at all and solely relies on how it has been built so we would always recommend attaching the PDF of the form as a Workflow Document.

Was this article helpful?
0 out of 0 found this helpful
I'm still stuck!

Comments

0 comments

Article is closed for comments.