Arbor Workflows: Naming a Workflow

Workflows have a title, called the Workflow Name, and an individual Name for Workflow Run. The workflow title appears in indexes and task notifications, while run names appear on Workflow Run and My Tasks pages. Run names can be dynamically generated using collected workflow data.

 

A workflow has two areas in which we can refer to a 'name'. The Workflow Name should be thought of as the title, and the Name of Workflow Run is the name for each individual time that workflow runs. 

 

Workflow Name

The Workflow Name can be set up when first building your workflow or from the Review & Test area. 

Make sure it's both clear and concise, as this name will be how your workflow is displayed in the workflow index and will be included in any task notifications to the recipients of those steps. 

 

Name for Workflow Run

You should also give a name to the workflow run. Arbor Workflows will use this name on the Workflow Run and My Tasks pages.

You have the option to dynamically set workflow names by using data collected during the workflow run. This can be done using dynamic data, similar to how you reference data in other parts of the workflow.

For instance, consider a scenario where you're running a Medical Note workflow. In this case, the workflow name could logically be the pupils name along with the of the incident. As shown in the example below, you can reference the data collected (from the trigger form) to set the workflow name when it's running. 

 

 

Was this article helpful?
0 out of 0 found this helpful
I'm still stuck!

Comments

0 comments

Article is closed for comments.